![unifi controller offline unifi controller offline](https://cdn.arstechnica.net/wp-content/uploads/2015/10/Review-chart-template-final-full-width-3.002-640x470.png)
Here’s the entry for a time when the device was shown as offline: - UniFiClient However, I still don’t see a reason why this is happening. Since this has been going on for a while, I thought I try to analyze by setting the debug level of the Unifi binding to debug. However, randomly the device will show “off” even though it is clearly online and also shows so in the Unifi controller. when I leave the house, my smartphone is not longer logged into the Wifi network - therefore the status of the device will be set to “off” and I will receive a notification. After signing in, navigate to Settings > Controller.Under Controller Settings, enter the IP address of your controller and make sure the Override inform host with controller hostname/IP box is checked.
#UNIFI CONTROLLER OFFLINE SOFTWARE#
Below is a list of the equipment that you will need to set up the Unifi Network Controller software on your Raspberry Pi. You will also be able to use this dashboard to see the statistics of your UniFi network. Fix UniFi Devices Disconnecting by Force Overriding Inform Host. Using the UniFi network controller, you can manage all the UniFi devices that are a part of your network.
![unifi controller offline unifi controller offline](https://www.tembolok.id/wp-content/uploads/2016/07/direct-url-unifi-firmware-e1493442912711-1000x257.png)
I am doing presence detection using the online/offline status of a device, i.e. In this case, the IP address of my UniFi controller is 10.0.0.5. There is this interesting issue I have with the Unifi binding. Since devices retain controller config locally once provisioned from controller, no controller need be present for the network to continue on.